What are these? Socket like parts are brass and two brass rings of different sizes, wrench looking part is steel. But the brass sockets don't seem to fit the wrench part.

What is this black metal part marked Cannondale on it? It is sealed in a clear bag with two 1.5 screws. The black metal part is approx. 6 x 2 x 1/3and

Metal tool, clamps onto a table, handle spins wheel and another piece attached also spins : r/whatisthisthing

Made of wood and aluminum. Both parts are hollow. The egg shaped part is screwed on and has an o-ring seal, spins smoothly on a bearing. Smaller end has a sliding clip

Metal detecting find. Body is made of brass or bronze metal, has screws holding small wire or rod (wire is .054” thick or roughly 16 gauge). Object appears incomplete and missing much

Unknown tool identification - Anyone know what these are? : r/watchmaking

What are these? Socket like parts are brass and two brass rings of different sizes, wrench looking part is steel. But the brass sockets don't seem to fit the wrench part.

Three pieces of plastic connected by metal rod. Middle part slides up and down freely except for resistance when it it's the spring. Threaded rod in one blue piece. Plastic feels like

What is this black metal part marked Cannondale on it? It is sealed in a clear bag with two 1.5 screws. The black metal part is approx. 6 x 2 x 1/3and

What are these? Socket like parts are brass and two brass rings of different sizes, wrench looking part is steel. But the brass sockets don't seem to fit the wrench part.

Metal detecting find. Body is made of brass or bronze metal, has screws holding small wire or rod (wire is .054” thick or roughly 16 gauge). Object appears incomplete and missing much of original form. Item is 2” wide by 1” tall. : r/whatisthisthing

Made of wood and aluminum. Both parts are hollow. The egg shaped part is screwed on and has an o-ring seal, spins smoothly on a bearing. Smaller end has a sliding clip